Sale!

Ghost Fish Water Based Siliconate Concrete Sealer

$199.00 $169.00

Ghost Fish is a water-based, siliconate solution designed to impart water repellency and stain resistance to a wide variety of concrete and aggregate surfaces. The siliconate reacts with the carbon dioxide in the air to form an insoluble water-resistant treatment within 24-72 hours after application. Ghostfish Sealer is the protection you need without the shine. Like magic, it does the work without being seen. Perfect product for a flat finish. Since some customers don’t like the shine this will keep them protected without changing the look of the substrate.

SKU: GF5 Category:

Description

Ghost Fish is a water-based, siliconate solution designed to impart water repellency and stain resistance to a wide variety of concrete and aggregate surfaces. The siliconate reacts with the carbon dioxide in the air to form an insoluble water-resistant treatment within 24-72 hours after application. Ghostfish Sealer is the protection you need without the shine. Like magic, it does the work without being seen. Perfect product for a flat finish. Since some customers don’t like the shine this will keep them protected without changing the look of the substrate.

Ghost Fish Paver Sealer Benefits:

  • Single Component

  • One Day Process (No Downtime)

  • Siliconate Solution

  • Natural Look

  • VOC Compliant in All 50 States

  • User Friendly and Environmentally Safe

  • Minimal Toxic Odor

  • Inhibits Algae & Mold Growth 

DIRECTIONS FOR USE:

We recommend wearing protective goggles and latex gloves. For best results, apply Killer Orca at temperatures between 60° F and 90° F. In cooler conditions, the sealer should be warmed to approximately 70° F. Do not apply if surface or ambient temperature s below 50°F. A test for compatibility, penetration and adhesion is recommended. If the temperature is going to drop below freezing (32° F) make sure sealer has time to cure.

MIXING:

Ghost Fish Sealer is a siliconate solution which comes packaged in a 5-gallon. Ghost Fish paver sealer can be diluted, after mixing with up to 1 parts water and 1 part sealer and makes up to 10 gallons. 

DRYING TIME:

Ghost Fish sealer will normally dry in sunny areas within approximately 1 hour. Shaded areas, lower temperatures or high relative humidity will slow the drying process. The surface may be open to foot traffic in 24 hours and to vehicular traffic in 48 hours. To minimize tire marks, vehicles should not make sudden stops or tight turns.

CLEANUP:

  • Immediately flush and agitate pump system after sealing with a mixture of 3 gallons water and 8 ounces of pine sol

  • Flush out the pump system with 5 gallons of fresh water – 1 gallon every 5 minutes

  • Always run water through the pump the next morning to have it ready for use

  • View Seal ‘n Lock Pail Pump Cleanout Instructions

NOTES:

  • Pavers with high absorption rate will require additional top coats of sealer to provide a protective barrier and desired enhancement.

  • Ghost Fish Sealer is not intended for submerged surfaces.

MAINTENANCE:

Periodic washing of pavers with a mild detergent to keep the area clean is recommended.

DO NOT USE ACIDSGasoline, hydraulic fluids and motor oil spills should be removed from the surface of the pavers as soon as possible. We recommend that surfaces previously sealed with Super Wet Look® should be cleaned and resealed every 3 years, depending on environmental exposure and traffic.

CAUTION: Too many coats of sealer may induce a slippery condition. May be slippery during the application if walked on. May cause skin and eye irritation. Do not take internally. Wear mask. All label directions should be read thoroughly before use.

Additional information

Weight44 lbs
Dimensions12 × 12 × 16 in